I think this is the route I will take, thanks all. Evan
> On Jan 18, 2025, at 12:27 PM, Phillip Matheson via KRnet > <krnet@list.krnet.org> wrote: > > I agree in part John , but I put mould release on the bolts, then wipe it > all off the same as when glassing from a mould, from bolts, I glue inside > the spar with a pipe cleaner and resin , then, you can crack them with a > spanner and remove if needed, much easier then heaps of epoxy. After many > years, the moisture from the timber can, and will corrode the bolts, if the > timber hole is not sealed. > > Phil matheson. > > Sent from my iPhone > >>> On 18 Jan 2025, at 03:08, shafferj45...@twc.com wrote: >>> >> Since you are talking about the AN-3 bolts, I do not think anyone has. When >> I installed my WAF's, I filled the holes with epoxy, to seal an >> >> >> >> -- >> KRnet mailing list >> KRnet@list.krnet.org >> https://list.krnet.org/mailman/listinfo/krnet > -- > KRnet mailing list > KRnet@list.krnet.org > https://list.krnet.org/mailman/listinfo/krnet
-- KRnet mailing list KRnet@list.krnet.org https://list.krnet.org/mailman/listinfo/krnet
