Craig. Your idle should be set at appx 800 rpm. It is difficult to get mixture to kill engine at idle. The Ellison is actually smoother at idle with some leaning and the same goes when running in the 1000 - 1500 range. Go full rich on take off and then lean accordingly. That engine is not the original that was installed in 2005. The engine you have in the plane was short block and bearing built by Roy Szarafinski and the heads built by Mark at Falcon. That engine is no where near needing a rebuild. You need to read the log books to find the exact install date and determine the actual hours on that engine. That engine was in prime flight condition when you acquired it. It should be flight ready unless you made major changes that would affect its performance.
Mark Jones Oldsmar, Fl N771MJ “WunderBird” www.flykr2s.com flyk...@gmail.com > On Jan 3, 2019, at 9:41 PM, Craig Williams via KRnet <krnet@list.krnet.org> > wrote: > > Weather finally cooperated today and I got some high speed runs in today. > Could fly tomorrow but I am a bit concerned as I seem to have no mixture > control on the EFS-3A. I pull full lean and it will not kill the engine. > Just leans it a bit. Anyone seen this symptom? Can you kill the engine with > the mixture? I also have a some roughness from 1000 to 1500 rpm. Still > diagnosing but I think it may be time for a rebuild as I believe it has been > on the plane since 2005. Had a few other minor issues but she wanted to lift > off at 60 so I stayed below that. Handling was easy and I am ready to fly if > I can get this Ellison issue figured out. > > Craig > N886MJ > > _______________________________________________ > Search the KRnet Archives at > https://www.mail-archive.com/krnet@list.krnet.org/. > Please see LIST RULES and KRnet info at http://www.krnet.org/info.html. > see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change > options. > To UNsubscribe from KRnet, send a message to krnet-le...@list.krnet.org _______________________________________________ Search the KRnet Archives at https://www.mail-archive.com/krnet@list.krnet.org/. Please see LIST RULES and KRnet info at http://www.krnet.org/info.html. see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change options. To UNsubscribe from KRnet, send a message to krnet-le...@list.krnet.org
