Mark check to make sure the panel is not too thick and preventing the unit connecting to the cage.I had a KLN that did the same thing it looked like it was in but it wasnt Hope it helps Mark
------------------------------ On Sun, Nov 3, 2013 8:05 PM GMT Mark Langford wrote: >Does anybody have an ICOM IC-A200 radio installed and working in their >instrument panel? I finally "finished" my panel last night and everything >tested fine, except my ICOM IC-A200 radio. I spent a lot of time making sure >I wired it correctly, and even used new connector pins so I wouldn't be >splicing wires. I've been over every wire five times in the last 24 hours, >and it still doesn't work. If somebody has a working installation and could >pop this thing in their panel to see if it works, I'd appreciate it. > >I'm using the mounting tray, and would assume others would too since it weighs >almost nothing and makes it easily removable. So loosening the 3/32" allen >screw on the face of the radio releases the radio and it slides out the front >of the tray. Removal and the checkout operation should take under five >minutes. Otherwise, I'll send it to ICOM for a checkout, but that will >certainly cost me a lot more than just the postage, and probably more time. >It would really help me troubleshoot this thing, and would quickly tell me if >I need to buy another radio. > >See enclosed photo of the operating panel, well...everything but the radio! >Total current draw is only 1.43 Amps. I'll go ahead and put it in the plane >and start hooking up sensors to make some of those red X's go away, and to >make forward progress for a change... > >Thanks, > >Mark Langford >ML at N56ML.com >website at http://www.N56ML.com >-------------------------------------------------------- >
