Gagan
Firstly,Its always better to configure sendmail using m4 macro with .mc file
then further for tuning u can go for .cf file.
Secondly, If you can configure sendmail then you don't require any SMTP
server coz that itself will act as SMTP server, What you will need is an
internet gateway to through your mails on internet or if you are having Wan
Ip or you are using dialup connection on that machine then theres again no
use for internet gateway
Regards,
Dhruv
Network Engineer
FCS Software Solutions
A-86, Sector-57
Noida-201301
Ph. +91-0120-2583703 Xtn-276/123(India)
Ph. +1-866-388-3432 Xtn.-334/345(US)
-----Original Message-----
From: Gagan Grewal
To: multiple recipients of
Sent: 2/26/03 3:49 PM
Subject: [ilugd]: Is anybody using sendmail from their PCs ?
Hi Folks!
I want to know wether sendmail can/should be used from a PC or not ?
I was able to send mails over to internet using sendmail from my PC
after
clobbering a couple of lines in the sendmail.cf. It works just fine ...
but
seems a little slow.
I want to know wether I can use sendmail from my PC to transfer mails
over
to an SMTP server (having a registered address) such as VSNL since I
have a
valid mail account on that server ... and let that server do the
remaining
of sending job. ( Like one usually does using programs like Outlook,
Ximian,
KMail, Mutt etc. )
Has anybody configured sendmail on his PC in order to relay
outbound/internet
bound mails through an SMTP server ?
I tried SMART_HOST and nullclient ... but doesn't work.
Regards,
Gagan.
================================================
To unsubscribe, send email to [EMAIL PROTECTED] with unsubscribe in
subject header. Check archives at
http://www.mail-archive.com/ilugd%40wpaa.org
================================================
To unsubscribe, send email to [EMAIL PROTECTED] with unsubscribe in subject header.
Check archives at http://www.mail-archive.com/ilugd%40wpaa.org
