IMHO your problem is unrelated to zPDT, it is just a erroneous definition.
Reason:
When you work with HCD you define something which may or may not be
close to your physical setup.
Just imagine you have four z16 machines and dozen of D8K dasd boxes. And
huge FICON directors.
You can work with such definitions, however it cannot be activated
without the equipment.
But in your case the HCD warns you the definitions are simply wrong. It
doesn't matter whether your hardware is real or emulated.
--
Radoslaw Skorupka
Lodz, Poland
W dniu 23.09.2024 o 21:39, Binyamin Dissen pisze:
I am trying to define what is needed to support a DS8* on a zPDT (no, the
hardware will never be connected - just to try to simulate an issue).
I read the manuals and it appears that switches and control units must be
defined (used 2107-IBM). I then defined the dasd as 3380-CJ2 and connected it
to the two switches.
But when I tried to build the production IODF I got
W CBDG061I Switch control unit must be defined for switch 04.
W CBDG061I Switch control unit must be defined for switch 05.
I am guessing that the 2107-IBM is not correct. What would be correct?
Is this possible w/o the CU hardware?
--
Binyamin Dissen <[email protected]>
http://www.dissensoftware.com
Director, Dissen Software, Bar & Grill - Israel
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
