Hi! When I edit my data, for instance wm editing, I do not see the changes applied to the original image. To make you understand what I do:
Open up freeview, load the image, Wm and brainmask, with wm at the top. Then I go into voxel edit, press recon edit, and start filling in topographical defects and do some wm editing. HOWEVER, after I run recon all (recon-all -autorecon2 -autorecon3 -subjid anon)and it's finished without problems, I do not see the edits done on my image. Sure, I see the yellow colour which I filled some spots with, but I was thinking that I would see an edited image, that is with pia (topographical defects) and wm surface going out to the areas I edited. Not only yellow filling which was there before since I edited. Am I doing something wrong? Is the reconprocessed images hidden out there somewhere? Freesurfer team, please help! Best, MAX
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
