Hi Antonella
talairach.lta and .xfm are linear transforms to a Talairach coordinate
system. The .m3z is a nonlinear morph and will give you much higher
anatomical resolution.
cheers
Bruce
On Thu, 11 Aug 2011, Antonella Kis wrote:
Dear Freesurfers,
I am ready to run the make_average_subject and I need to specify -xform for
the talairach transform: talairach.lta , talairach.m3z or talairach.xfm. What
is the
difference between this and what should I use for the make_average_subject in
order to prepare my data for the GLM analysis?
Thank you very much for your help.
Antonella
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
