HiBruce,
I 1). My LNX3 the only one which is working is a Fedora Linux, Kernel Linux 2.6.32.23-170.fc12.x86_64, GENOME 2.28.2 LNX2 where I get the weird surface display is a Linux CENTOS x86_64, GENOME 2.16.0 The Analyst computer where I got the multiple frames error is a Linux, Kernel Linux 2.6.35.13-91.fc14.x86_64, GENOME 2.32.0 2). Also, when I am doing my data analysis after running the recon -all and qcache -all for my subjects, what is the best steps order to be followed. While reading the FreeSurfer Troubleshooting Reconstruction Work suggests the user to run all these steps at once before beginning to inspect the data since this allows the user to see the final complete output before deciding on any interventions.But this steps are in a different order that the one in the tutorial and also in a different order that the one described in the attached document. 8. Check the segmentations - After editing the wm.mgz volume run the following steps: -normalization -maskbfs -segmentation -autorecon2-wm -autorecon3. Thank you for your help! Antonella
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
