The Volumes module in 3D slicer (v3) will load mgz files. You can use
the Model Maker module to create models of your structures using the
FreeSurfer label codes.
http://www.slicer.org/
_________________________
Jeffrey J. Dewey
Center for Neurological Imaging
Brigham and Women's Hospital
1249 Boylston St, 3rd Floor
Boston, MA 02215
jde...@bwh.harvard.edu
On Mar 17, 2009, at 3:26 PM, Alexa Nardelli wrote:
Hi,
I have used FreeSurfer volumetrics to obtain various volumes of some
subcortical structures. I would like to obtain a 3D image of each of
these subcortical structures. I have tried importing the volumes
into Matlab, however Matlab doesn't recognize the mgz file. Any
suggestions on how I could go about doing this?
Thanks,
Alexa
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to
whom it is
addressed. If you believe this e-mail was sent to you in error and
the e-mail
contains patient information, please contact the Partners Compliance
HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to
you in error
but does not contain patient information, please contact the sender
and properly
dispose of the e-mail.
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
