read_curv will return that also:
[thickness_vector, nfaces] = read_curv('lh.thickness') ;
I'm a bit worried that you have a dimension mismatch. That shouldn't
happen.
Bruce
On Tue, 11 Sep 2007, Juergen Haenggi,
Psychological Institute wrote:
Dear Freesurfer users
I computed ?.volume files by using several commands sent by Bruce. Instead of
using the save_mgh.m command, which not really worked because there was a
dimension mismatch later when using mri_concat, we used write_curv.m. I need
the number of faces in the surface to write ?h.volume files. Where can I get
these numbers? Is it the file called f created in the Matlab current
directory after running read_curv multiplying area times thickness, and
write_curv?
Thanks in advance
Best regards
Juergen Haenggi
-------------------------------------------------
Juergen Haenggi
Ph.D. (Dr. des.)
Division of Neuropsychology
Institute of Psychology
University of Zurich
Binzmuehlestrasse 14, PO Box 25
8050 Zurich, Switzerland
0041 44 635 73 97 (phone office)
0041 76 445 86 84 (phone mobile)
0041 44 635 74 09 (fax office)
BIN 4.D.04 (office room number)
[EMAIL PROTECTED] (email)
http://www.psychologie.uzh.ch/neuropsy/ (website)
http://www.juergenhaenggi.ch (private website)
-------------------------------------------------
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
