Infill overlap percentage.
https://support.ultimaker.com/hc/en-us/articles/360012607079-Infill-settings
On Saturday, August 29, 2020, 10:43:03 PM MDT, Gene Heskett
<[email protected]> wrote:
On Sunday 30 August 2020 00:03:58 Chris Albertson wrote:
> Do the same as the printed timing pulleys. Make the center of the hub
> in steel and epoxy the steel to the plastic. You may need to bore out
> the plastic
>
Probably, and that will involve finding a better actual center than
currentlty exists in the .stl, its off center a good .25mm off the
printer. Doing that can't help but improve the performance because then
the thing can be sized to very precisely fit 99% of the splines at max
engagement.
But now I have a question for the cura 4.7.0 experts. The inside finish
of the first one I made is flawless, but at the precise beginning of the
splines, the inner wall is no longer bonded to the rest of it! How can
this be made to be bonded the full height of the wall?
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
