Thank you guys for all the replies :) I'll give them a try and see how it goes.
El mié., 19 ago. 2020 a las 9:54, Todd Zuercher (<[email protected]>) escribió: > I think I'd prefer a model with a pressure guage (but you could always add > one in-line after the pump). And for Linuxcnc I'd prefer one without the > timer features and do the timing control in Linuxcnc. > > Todd Zuercher > P. Graham Dunn Inc. > 630 Henry Street > Dalton, Ohio 44618 > Phone: (330)828-2105ext. 2031 > > -----Original Message----- > From: Leonardo Marsaglia <[email protected]> > Sent: Tuesday, August 18, 2020 7:06 PM > To: Enhanced Machine Controller (EMC) <[email protected]> > Subject: [Emc-users] OT: Anyone tried these auto lube units? > > [EXTERNAL EMAIL] Be sure links are safe. > > Hello guys, > > I'm about to purchase some automatic lube units for a copying lathe I'm > retrofitting with LCNC and for the router project (which is alive again > finally). > > I'm planning to use an auto lube unit like this: > > > https://www.ebay.com/itm/CNC-Electromagnetic-Lubricant-Pump-Automatic-Lubricating-Oil-Pump-220V-HTS02-2L/184283971779?hash=item2ae82e40c3:g:TCMAAOSwiI1eYgJZ > > > Do you have any experience with these? Should I try something a little > more expensive just to play it safe? > > Thanks as always! > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
