I installed linuxcnc from git sources.
The mill config seems to work OK with my old 'wheezy' config as
converted by linuxcnc_2.9.0~pre0_amd64. Manual control seems to work.
MDI seems to work.
The lathe config from 'wheezy' would not work after conversion by
linuxcnc_2.9.0~pre0_amd64.
I used the config file from linuxcnc_2.9.0~pre0_amd64 sources. That
appears to function.
With both the installed and the 'run in place' versions,
the home Axis button for the Z axis does nothing. Clicking the button a
second time results in the expected 'are you sure' pop-up, but, does
nothing. The Z Axis is not homed. No 'homed' mark appears in the
Preview window. MDI does not work.
The X Axis is homed when the Home Axis button is clicked.
Machine->Homing->Home Axis Z does home the Z axis and MDI works.
On startup, I see:
LINUXCNC - 2.9.0~pre0
Machine configuration directory is
'/home/tomdean/linuxcnc/configs//by_machine.sherline.SherlineLathe'
Machine configuration file is 'SherlineLathe_inch.ini'
Starting LinuxCNC...
Found file(lib): /usr/share/linuxcnc/hallib/core_stepper.hal
Found file(REL): ./standard_pinout.hal
note: MAXV max: 0.360 units/sec 21.600 units/min
note: LJOG max: 0.360 units/sec 21.600 units/min
note: LJOG default: 0.180 units/sec 10.800 units/min
note: jog_order='ZX'
note: jog_invert=set(['X'])
task: main loop took 0.184661 seconds
task: main loop took 0.202663 seconds
On exit, I see:
Shutting down and cleaning up LinuxCNC...
task: 2258 cycles, min=0.000053, max=0.202663, avg=0.010238, 2 latency
excursions (> 10x expected cycle time of 0.010000s)
This worked with the 'stretch' and 'wheezy' versions of linuxcnc.
Any ideas?
Tom Dean
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
