On Fri, 20 Dec 2019 at 03:34, Thomas D. Dean <[email protected]> wrote: > > I did a 'git pull' and built the 'run in place' version. > > I modified the SherlineLathe_inch.ini file to have 2 axis and removed > the [Y Axis] and [joint_1] sections. I changed the [Z Axis] [joint_2] > to [Joint_1].
The patch that Dewey made should have not required any config changes (nor a recompile for that matter). It was a tweak to make the Axis GUI understand 3-axis lathe configs. You had a consistent config that Axis wasn't sure how to handle, and now you have made the config inconsistent (though if it loaded, Axis could probably cope now) That said, the conversion tool was _meant_ to change lathes from 3-axis to 2-axis: -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1912 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
