I would also like to have EQ settings set per mode and/or per mic
socket. Switching between audio data modes and a microphone with high
frequency boost set on the TX equaliser and audio data modes is not
possible without spending a couple of minutes re-setting the equaliser
each time the microphone is used!
Another area where settings need to be stored is for the K3 to store
whether the ATU is in use on a per antenna socket basis, it's nice to be
able to label the antenna type but being able to set the ATU and have it
remember would be more practical use.
There are a few of these irritations that need attention, another being
the previously mentioned difficulty of switching through the VFO
memories... You can't use the K3 as a channelised radio at the moment
without a lot of button pushing. Also, it won't scan on 50 MHz with a
message of "SCAN NOT ALLOWED ON THIS BAND"... What's that all about?
One day, maybe it will all be fixed and we'll have to find something
else to grumble about <G>
73 Dave, G4AON
K3/100 #80
===============
I wonder if 1.1.3.6 allows you to save EQ settings? I would dearly like
to have this feature. My wife Linda is also licensed and it would be
great if we could save the two different EQ setups.
73 Ian
--
Ian J Maude, G0VGS
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
