Phil, The Cady book being referenced here is the KX3 book which is still first edition only as far as I know. The K3 book is now in second edition.
phil On Apr 10, 2014, at 8:53 AM, Phil Wheeler <[email protected]> wrote: > It may depend on the edition you have. I have the 2nd edition and page 147 > relates to the KRX3 subreceiver. > > Phil W7OX > > On 4/10/14, 6:26 AM, Phil Hystad wrote: >> I probably looked in the index and found nothing. Something like that needs >> to be in the index. I almost always use an index before looking at the >> table of contents when I search for something. I am a believer in that an >> index is a rich information source (or should be) and should contain a lot >> more information than just page number look up such as cross references, >> associations, and even new information when it fits the content. >> >> phil >> >> >> On Apr 9, 2014, at 9:31 PM, Jim Bennett <[email protected]> wrote: >> >>> It be on page 147 in my book. Figure 9.17 shows a complete >>> K3-->KPA500-->KAT500 setup. This is exactly how I've got mine set up. >>> Nothing in the index, but it is in the TOC in the front. :-) >>> >>> Jim / W6JHB >>> >>> >>> On Wednesday, Apr 9, 2014, at Wednesday, 9:25 PM, Phil Wheeler wrote: >>> >>>> Surprising, because I couldn't find any mention of the KPA500 in his K3 >>>> book by searching the pdf version. Maybe I did a typo. >>>> >>>> 73, Phil W7OX >>>> >>>> On 4/9/14, 8:55 PM, Phil Hystad wrote: >>>>> Jim, >>>>> >>>>> I think you mentioned the Cady KX3 book to me on a previous similar >>>>> message. If not, it was someone else. But, at that time, I searched for >>>>> the diagram and could not find it. Upon the message below I searched >>>>> again, page by page. Finally found it. Now, I looked in the >>>>> table-of-contents but for some strange reason I never saw that section on >>>>> the KX3 and KPA500. >>>>> >>>>> I do have a Diamond CX-210 two-position switch. I have a bunch of those >>>>> in my shack, also one 3 position. >>>>> >>>>> 73, phil, K7PEH >>>>> >>>>> >>>>> On Apr 9, 2014, at 7:29 PM, Jim Bennett <[email protected]> wrote: >>>>> >>>>>> phil, >>>>>> >>>>>> I'm doing exactly that - I have a KX3 and a K3 that share a KPA500, >>>>>> KAT500, and several antennas. I went by the diagram in Fred Cady's book >>>>>> on the KX3. Works like a charm. I can get up to 250 watts out with the >>>>>> KX3 driving the amp at 12 watts. And, no, I do not disconnect anything >>>>>> when I want to use the KX3 with the amp and tuner. Just make sure that >>>>>> (1) the K3 is powered off if you are using the KX3, and (2) your coax >>>>>> switch connecting the two radios to the amp has very good isolation. I'm >>>>>> using a two position Daiwa coax switch at the moment. >>>>>> >>>>>> Let me know if you need more info. I've been using this configuration >>>>>> for a few months now. >>>>>> >>>>>> Jim / W6JHB > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
