It may depend on the edition you have. I have the
2nd edition and page 147 relates to the KRX3
subreceiver.
Phil W7OX
On 4/10/14, 6:26 AM, Phil Hystad wrote:
I probably looked in the index and found
nothing. Something like that needs to be in the
index. I almost always use an index before
looking at the table of contents when I search
for something. I am a believer in that an index
is a rich information source (or should be) and
should contain a lot more information than just
page number look up such as cross references,
associations, and even new information when it
fits the content.
phil
On Apr 9, 2014, at 9:31 PM, Jim Bennett
<[email protected] <mailto:[email protected]>> wrote:
It be on page 147 in my book. Figure 9.17 shows
a complete K3-->KPA500-->KAT500 setup. This is
exactly how I've got mine set up. Nothing in
the index, but it is in the TOC in the front. :-)
Jim / W6JHB
On Wednesday, Apr 9, 2014, at Wednesday,
9:25 PM, Phil Wheeler wrote:
Surprising, because I couldn't find any
mention of the KPA500 in his K3 book by
searching the pdf version. Maybe I did a typo.
73, Phil W7OX
On 4/9/14, 8:55 PM, Phil Hystad wrote:
Jim,
I think you mentioned the Cady KX3 book to me on a previous similar message.
If not, it was someone else. But, at that time, I searched for the diagram and
could not find it. Upon the message below I searched again, page by page.
Finally found it. Now, I looked in the table-of-contents but for some strange
reason I never saw that section on the KX3 and KPA500.
I do have a Diamond CX-210 two-position switch. I have a bunch of those in my
shack, also one 3 position.
73, phil, K7PEH
On Apr 9, 2014, at 7:29 PM, Jim Bennett<[email protected]> wrote:
phil,
I'm doing exactly that - I have a KX3 and a K3 that share a KPA500, KAT500, and
several antennas. I went by the diagram in Fred Cady's book on the KX3. Works
like a charm. I can get up to 250 watts out with the KX3 driving the amp at 12
watts. And, no, I do not disconnect anything when I want to use the KX3 with
the amp and tuner. Just make sure that (1) the K3 is powered off if you are
using the KX3, and (2) your coax switch connecting the two radios to the amp
has very good isolation. I'm using a two position Daiwa coax switch at the
moment.
Let me know if you need more info. I've been using this configuration for a few
months now.
Jim / W6JHB
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
