Thanks Jack. I figured that was the case. What I want(ed) to do is drive the 6-pack x-bar switch which has a tribander on it so 10-15-20 will be mapped to the same output PLUS drive a 6-band bandpass filter which needs to have separate outputs for 10-15-20. Any ideas? Cheers, Fred KE7X
-----Original Message----- From: Jack Brindle [mailto:[email protected]] Sent: Friday, March 08, 2013 9:44 AM To: Cady, Fred Cc: [email protected] Subject: Re: [Elecraft] RC2 - high side and low side different Fred; If you mean the KRC2, the high and low side drivers are locked together in hardware, so no they cannot be separated. With 16 configurable selections, it meets most folks needs. This is also a good time to remind folks that the final KRC2 configuration tool is on the Elecraft web site. The text may say "beta", but it is the real thing. Jack Brindle, W6FB Sent from my iPad On Mar 8, 2013, at 7:17 AM, "Cady, Fred" <[email protected]> wrote: > Can the RC2 controller be set up so the high side driver configuration > is different than the low side? > > Thanks and cheers, > Fred KE7X > > Fred Cady > fcady at ieee dot org > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net Please help support this email > list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
