On Wed, Aug 29, 2001 at 10:03:57PM -0400, [EMAIL PROTECTED] wrote: > I have a Linksys Etherfast 10/100, I think it's revision 3, though. All you > should need to do is enable the driver in the kernel, compile, then, if you > compile it as a module (I compile it statically), you'll need to make modules > and make modules-install, and modprobe/insmod the module. Turn off PnP OS in > your BIOS if it's on.
That last point is a good one. I couldn't get that card working until PNP
was off in the bios.
Note that since this is Debian, make-kpkg is probably preferred to the
basic "make bzImage; make modules; make modules-install".
Mike
pgpwN1MDlMFDM.pgp
Description: PGP signature
