On Wed, 29 August 2001, "Michael P. Soulier" wrote: > > On Wed, Aug 29, 2001 at 10:03:57PM -0400, [EMAIL PROTECTED] wrote: > > I have a Linksys Etherfast 10/100, I think it's revision 3, though. All you > > should need to do is enable the driver in the kernel, compile, then, if you > > compile it as a module (I compile it statically), you'll need to make > > modules > > and make modules-install, and modprobe/insmod the module. Turn off PnP OS > > in > > your BIOS if it's on. > > That last point is a good one. I couldn't get that card working until PNP > was off in the bios. > > Note that since this is Debian, make-kpkg is probably preferred to the > basic "make bzImage; make modules; make modules-install".
Ok, a few things I'm having trouble with.
1) I can't get into my BIOS. I've tried, but I think I killed the access
prcedure. I have put a new hard drive in this machine so it doesn't behave
like the Compaq website tells me to. It says to hit F10, but that doesn't do
anything. If anyone knows about Compaqs, I have a Presario CDS 982 (about 5
years old)
2) I have a USB card plugged into another PCI slot, and it is getting an IRQ
assigned. I don't know why this card is not. The output looks similar for the
two cards:
~# cat /proc/pci
...
Bus 0, device 19, function 0:
USB Controller: VIQ Technologies, Inc. UHCI USB (rev 4).
IRQ 11.
Master Capable. Latency=66.
I/O at 0x1880 [0x181f].
Bus 0, device 20, function 0:
Ethernet controller: PCI device 1317:0984 (Bridgecom, Inc) (rev 17).
Master Capable. Latency=66. Min Gnt=254.Max Lat=255.
I/O at 0x1000 [0x10ff].
Non-prefetchable 32 bit memory at 0x10000000 [0x100003ff].
Like I said, I don't kno why there is no IRQ for the NIC. I've tried compiling
the code you sent me, I'm attaching the output I got back. I used the command
I found in the readme file on the disk. I used the code you sent me though...
-------------------------------------------------------------
Sign up for ICQmail at http://www.icq.com/icqmail/signup.html
tulip.out.gz
Description: Binary data
