Yeah, it's stories like that that made me seriously consider getting a manual adjuster instead. Unfortunately not many are made anymore as far as I can tell. Wichard makes manual adjusters, but they're just as expensive as a new hydraulic (and I couldn't figure out if they're easily available).
-Patrick On Fri, Dec 30, 2016 at 12:43 PM, <cnc-list-requ...@cnc-list.com> wrote: > From: David <davidrisc...@msn.com> > To: "cnc-list@cnc-list.com" <cnc-list@cnc-list.com> > Cc: > Date: Fri, 30 Dec 2016 19:47:44 +0000 > Subject: Re: Stus-List Fwd: Navtec 10 Series 7 > > I took mine to a truck repair shop after I paid a "Navtec Approved" > repair shop $500 only have it fail again in 14 months...no warranty so I > was stuck with another large bill. Didnt trust the repair so before going > offshore brought it to the truck shop to inspect and test. What cost $500 > would have cost $100 there. > > > David F. Risch > (401) 419-4650 (cell) >
_______________________________________________ This list is supported by the generous donations of our members. If you wish to make a contribution to offset our costs, please go to: https://www.paypal.me/stumurray All Contributions are greatly appreciated!
