John, have taken the liberty of forwarding this to the Cnc list.

> Subject: Re: Navtec 10 Series 7
> 
> John,
> 
> When you say failed, I assume that you mean the seals now don't.
> If so, Plenty of industrial hydraulics places in the GTA - would expect they 
> could fix?  
> 
> FYI - windstar (33-2) has no hydraulic adjuster, and if I understand 
> correctly the baby stay is intended used to control mast bend, similar to 
> backstab adjuster.  Perhaps the adjuster was an 'owner-upgrade'?  Did the PO 
> happen to include the original part?  (Look for a 1/2" stainless rod around 
> 12" and toggles etc...)
> 
> Good luck, dave.
> 
> 
> Sent from my iPhone
> 
>> On Dec 30, 2016, at 9:35 AM, John McKay <jmckay...@yahoo.ca> wrote:
>> 
>> 
>> 
>> The Navtec backstay adjuster failed on Enterprise this summer.
>> 
>> I know South Shore can repair it but it is a fairly expensive repair and 
>> searching on the net, most say a repair does not last that long.
>> 
>> Has anyone replaced their adjuster?
>> 
>> With what?
>> 
>> Approximate cost?
>> 
>> Or if repaired, where?
>> 
>> Guys around my yacht club says it is an easy fix, but they are mechanically 
>> inclined!
>> 
>> Thanks and Happy New Years
>> 
>> John on Enterprise
>> Komoka
>> 
>> 
>> 
>> 
_______________________________________________

This list is supported by the generous donations of our members. If you wish to 
make a contribution to offset our costs, please go to:  
https://www.paypal.me/stumurray

All Contributions are greatly appreciated!

Reply via email to