There was only a large bowmar hatch in the v birth of my 73 viking 33. Only a solar poweredvent in the head. Danny
Sent from my T-Mobile 4G LTE Device-------- Original message --------From: D Harben via CnC-List <cnc-list@cnc-list.com> Date: 12/6/2015 6:59 PM (GMT-05:00) To: cnc-list@cnc-list.com Cc: D Harben <sailadventu...@rogers.com> Subject: Re: Stus-List little A&H hatches on a LF38 Is the head hatch on the 70s Viking 33/34 the same? The Nicro 3" cap gives some sense of scale in the picture: Viking 34 Head Hatch Don V34NCYC On Dec 6, 2015, at 6:17 PM, s/v Johanna Rose via CnC-List <cnc-list@cnc-list.com> wrote: Fred, All of my hinges have one hole. The break occurred between the hole and the hinge joint. I have posted additional photos on my blog but no write up yet. I checked Wally’s site(our hulls are two numbers off), and it looks like his hinges are like mine with one big hole through the acrylic for each hinge. The latch on the other hand has two holes. Maybe around 1981, they changed the hinge? Here is the direct link to Wally’s page: http://www.wbryant.com/StellaBoat/Projects/deck/hatch/index.htm Thanks again for you input. - Paul E.1981 C&C 38 Landfall S/V Johanna Rose Carrabelle, FL http://svjohannarose.blogspot.com/ On Dec 6, 2015, at 2:11 PM, cnc-list-requ...@cnc-list.com wrote: Date: Sun, 6 Dec 2015 13:07:50 -0600 From: Frederick G Street <f...@postaudio.net> To: cnc-list@cnc-list.com Cc: PME <dre...@gmail.com> Subject: Re: Stus-List little A&H hatches on a LF38 Message-ID: <5296fd50-e2c9-41f5-bd42-89088414f...@postaudio.net> Content-Type: text/plain; charset="utf-8" Paul ? that looks pretty nasty; and those lenses don?t look like they?re original to me. The hinges have two holes for bolts; it looks like the one on the left of your photo cracked across those two holes. I have no clue where the other one came from, with one large bolt through it, unless it was drilled out from its original state. If you can get the hinge pin out, I?d be willing to bet you could use the one intact hinge from this hatch to have some new one machined out of aluminum, with the original hole pattern for the lens bolts. If you decide to go that route, let me know and I can have some lenses made up for you. I doubt you?re going to find a replacement hatch anywhere that will fit those dimensions without having to do a LOT of glass work; the pads in which they sit don?t match any after-market hatches I?ve ever been able to find, or I would have replaced mine long ago. ? Fred Fred Street -- Minneapolis S/V Oceanis (1979 C&C Landfall 38) -- on the hard in Bayfield, WI :^( _______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
