FWIW, the balsa on my 1990 34R is 3/4" thick on deck and the hull. All vertical walls of cockpit and coachroof and transom are solid laminate, w no core. The fiberglass unit that covers the companionway slides and moonroof has 3/8" balsa. I have samples from these areas.
Chuck Resolute 1990 C&C 34R Broad Creek, Magothy River, Md ----- Original Message ----- From: "Martin DeYoung via CnC-List" <cnc-list@cnc-list.comrtical Cc: "Martin DeYoung" <mdeyo...@deyoungmfg.com> Sent: Monday, September 28, 2015 1:35:45 PM Subject: Re: Stus-List Balsa core thickness On Calypso, built in 1970 at Bruckmann's, the deck balsa is nominally 1/2". When replacing failed balsa I have been purchasing 1/2" then sanding it down a little to leave room for epoxy and filler and the new epoxy/glass laminations. If you remove a fastener in the general area of the deck you would be able to verify that C&C did not use different thicknesses in newer designs/builds. Martin Calypso 1971 C&C 43 Seattle From: CnC-List [cnc-list-boun...@cnc-list.com] on behalf of Rick Brass via CnC-List [cnc-list@cnc-list.com] Sent: Monday, September 28, 2015 7:28 AM To: cnc-list@cnc-list.com Cc: Rick Brass Subject: Re: Stus-List Balsa core thickness Petar; If I recall correctly, it is about 3/8” – perhaps ½” Rick Brass Imzadi C&C 38 mk 2 la Belle Aurore C&C 25 mk1 Washington, NC From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of phorvati . via CnC-List Sent: Saturday, September 26, 2015 8:01 PM To: CNC boat owners, cnc-list <cnc-list@cnc-list.com> Cc: phorvati . <phorv...@gmail.com> Subject: Stus-List Balsa core thickness Does anyone know what the thickness of balsa core is along the geona track section of deck on 1976 C&C 38 Mk2 Petar _______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com