Wally, Hole saws! Way too obvious! Why was 1/4 inch too thick? Looks like you had plenty of room.
Joel On Mon, Aug 18, 2014 at 11:02 AM, Wally Bryant via CnC-List < cnc-list@cnc-list.com> wrote: > Jake wrote: > >> <snip> I think Wally made some or had some made. McMaster has a wide >> variety of plastics. Delerin would be my first choice of material. <snip> >> > Charlie said something about two pegs riding on the bearing, which is > different than my setup. I have the 'donut' with two set screws. > > But Delrin would be a good way to go. Easy to make if you have hole saws. > > There's a picture of it here <http://www.wbryant.com/ > StellaBoat/Projects/steering/bearing/sole/bs19.jpg> > on this page <http://www.wbryant.com/StellaBoat/Projects/steering/ > bearing/sole/replace.htm> > > Wal > > > _______________________________________________ > This List is provided by the C&C Photo Album > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go bottom of > page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > -- Joel 301 541 8551
_______________________________________________ This List is provided by the C&C Photo Album Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
