That's what I was describing in my earlier reply. Easy to do. Ends caps with eyes are relatively inexpensive. Just cut the rail leaving a little stub, insert end cap with eye and make the lifeline gate. Done.
If you don't have a lower rail and are worried about strength of the pulpit, you can install one with a couple of rail tees on the vertical pulpit section and a short section of rail. Would provide a lower rail to step over. Now that I visualize this, I might actually do this on Touche'. Dennis C. Touche' 35-1 #83 Mandeville, LA On Thu, Feb 6, 2014 at 12:19 PM, Prime Interest <primeinter...@gmail.com>wrote: > Take a look at > > > > http://www.barkers-island-marina.com/yachtworld/sail.htm > > > > the $19,900 C&C 32 .. photo #2 > > > > > > > > > > ed > > > > Prime Interest > > 1982 C&C Landfall > > Toronto, Canada > > > > *From:* CnC-List [mailto:cnc-list-boun...@cnc-list.com] *On Behalf Of *John > Russo > *Sent:* Thursday, February 06, 2014 12:52 PM > *To:* cnc-list@cnc-list.com > *Subject:* Re: Stus-List [SPAM] Climing over the stern rail is a pain > > > > Thanks Bob, that would be helpful. > > > > John > > > > johnrussob...@optonline.net > > > > *From:* CnC-List > [mailto:cnc-list-boun...@cnc-list.com<cnc-list-boun...@cnc-list.com>] > *On Behalf Of *Robert Abbott > *Sent:* Thursday, February 06, 2014 12:39 PM > *To:* cnc-list@cnc-list.com > *Subject:* [SPAM]Stus-List Climing over the stern rail is a pain > > > > John > > Our 32 has a lower rail and a gate up top.....looks to be factory but not > sure....can send you a pic offline if you want. > > Rob Abbott > AZURA > C&C 32 - 84 > Halifax, N.S. > > > > > On 2014/02/05 3:33 PM, John Russo wrote: > > > > I have a 32 with a double rail at the stern and am thinking about cutting > the upper and adding a gate. My swim ladder actually comes slightly above > the lower rail when up where it tie it. My concern is that I have a motor > mount and a 65 Lb outboard on the stern rail port side vertical post which > I will have to shift more to port but wondered about the rail strength > after cutting. Any thoughts? I am also looking for a lighter outboard > with a little less HP. > > > > John > > Arpeggio 32 > > Norwalk CT > > > > > > _______________________________________________ > This List is provided by the C&C Photo Album > http://www.cncphotoalbum.com > CnC-List@cnc-list.com > >
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
