Hi Robert,
Everything Darren says is correct. However, in your example below you
also removed:
ipv6 ospf 12345 area 0
You will still need to enable OSPFv3 (ipv6 ospf) under the interface in
12.2(33)SXJ. OSPFv3 doesn't have a "network" command.
For a more comprehensive list of which releases support the OSPFv2
interface enable command you can use feature navigator. Search for the
following feature names:
Area Command in Interface Mode for OSPFv2
Enabling OSPFv2 on an Interface Using the ip ospf area Command
Note: both names refer to the same feature, though in different trains.
The command is available on the cat6k starting with 15.0(SY).
Regards,
Paul
On 07/27/2013 10:52 AM, Darren O'Connor wrote:
Yes.
In your first config you are enabling ospf under the interface, under the
process, and you're also redistributing that same interface subnet under ospf
by using redistribute connected. You don't need both the interface config and
the process config. It doesn't break anything using both, but it makes it
difficult for others to troubleshoot later. If you did use both, the most
specific will 'win'
And yes, while your release is 'new', the train itself is old. Check here:
http://www.cisco.com/en/US/docs/ios-xml/ios/iproute_ospf/command/ospf-a1.html#wp1148191700
It shows which releases have this command enabled and when. The SX train is not
on that list
Thanks
Darren
http://www.mellowd.co.uk/
On 27 Jul 2013, at 16:41, "Robert" <[email protected]> wrote:
Hi,
older release? Just take a look, 12.2(33) was compiled in April 2012.
Until now I've had no problems to enable OSPF on the interface _and_ in
router ospf section of the config. (12.4 and 12.5 train for VXR chassis)
Do you mean this config is enough:
!
router ospf 12345
router-id 192.168.100.232
redistribute connected subnets
redistribute static
passive-interface default
no passive-interface Vlan50
network 192.168.100.0 0.0.15.255 area 0
!
ipv6 router ospf 12345
router-id 192.168.100.232
log-adjacency-changes
passive-interface default
no passive-interface Vlan50
redistribute connected
!
...
...
!
interface Vlan50
ip address 192.168.100.197 255.255.255.252
no ip redirects
no ip proxy-arp
ipv6 address x:x:x:x::y/126
ipv6 nd ra suppress
!
Without enabling OSPF on interface side?
Thanks,
Robert
On 27.07.2013 17:25, Darren O'Connor wrote:
The interface-level ospf command was not available in older releases.
A bit odd to enable OSPf on an interface under both router ospf and the
interface itself. I would stick to just one or the other
Date: Sat, 27 Jul 2013 15:43:52 +0200
From: [email protected]
To: [email protected]
Subject: [c-nsp] OSPF question
Hi,
I'm a little bit confused while configuring a CAT6509 switch with OSPF.
So far, I used on the c7206-VXR platform the following config:
!
router ospf 12345
router-id 192.168.100.232
redistribute connected subnets
redistribute static
passive-interface default
no passive-interface GigabitEthernet0/1.50
network 192.168.100.0 0.0.15.255 area 0
!
...
...
!
interface GigabitEthernet0/1.50
encapsulation dot1Q 556
ip address 192.168.100.197 255.255.255.252
no ip redirects
no ip proxy-arp
ip ospf 12345 area 0
ipv6 address 2001:5DD:50::1/126
ipv6 nd ra suppress
ipv6 ospf 12345 area 0
!
Now, with IOS "s72033-advipservicesk9_wan-mz.122-33.SXJ3" the statement
"ip ospf <process-ID> area 0" is missing.
!
interface GigabitEthernet4/21
switchport
switchport trunk encapsulation dot1q
switchport mode trunk
switchport trunk allowed vlan 50
no cdp enable
!
...
...
!
interface Vlan50
ip address 192.168.100.197 255.255.255.252
no ip redirects
no ip proxy-arp
ipv6 address x:x:x:x::y/126
ipv6 nd ra suppress
ipv6 ospf 12345 area 0
!
The "ip ospf area 0" command is unrecognized :-( Any ideas?
Regards,
Robert
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
