Hi, I'm a little bit confused while configuring a CAT6509 switch with OSPF. So far, I used on the c7206-VXR platform the following config:
! router ospf 12345 router-id 192.168.100.232 redistribute connected subnets redistribute static passive-interface default no passive-interface GigabitEthernet0/1.50 network 192.168.100.0 0.0.15.255 area 0 ! ... ... ! interface GigabitEthernet0/1.50 encapsulation dot1Q 556 ip address 192.168.100.197 255.255.255.252 no ip redirects no ip proxy-arp ip ospf 12345 area 0 ipv6 address 2001:5DD:50::1/126 ipv6 nd ra suppress ipv6 ospf 12345 area 0 ! Now, with IOS "s72033-advipservicesk9_wan-mz.122-33.SXJ3" the statement "ip ospf <process-ID> area 0" is missing. ! interface GigabitEthernet4/21 switchport switchport trunk encapsulation dot1q switchport mode trunk switchport trunk allowed vlan 50 no cdp enable ! ... ... ! interface Vlan50 ip address 192.168.100.197 255.255.255.252 no ip redirects no ip proxy-arp ipv6 address x:x:x:x::y/126 ipv6 nd ra suppress ipv6 ospf 12345 area 0 ! The "ip ospf area 0" command is unrecognized :-( Any ideas? Regards, Robert _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
