> How do I make this happen on the HQ router?

Each l2tp tunnel will have its own vc:  "sh l2tun all"

You obviously have thoughts this all out as your logic for how it will and should work is sound.

We are doing a very similar setup over here at the UofMn and this is working well for us.


Regards,
Ge Moua | Email: [email protected]

Network Design Engineer
University of Minnesota | Networking & Telecommunications Services



Ziv Leyes wrote:
Hi,
I'm trying to make sure this following scenario can work.
3 remote sites, one is the HQ which has a switch that handles 2 vlans, let's 
say vlan 10 and vlan 20.
The other two branches needs to be connected to the HQ and have a flat LAN 
between them and the HQ, but each branch to it's own vlan, branch 1 to vlan 10 
and branch 2 to vlan 20. They must NOT see each other's traffic.
Every site has a switch and a router (C2801 I think) Is it possible to do?
If yes, then I was thinking about L2TPv3, but in this case I'd need to make two 
different xconnections between HQ-->Branch 1 and HQ-->Branch 2.
How do I make this happen on the HQ router? I was thinking to bring the vlans 
via a trunk from the switch and then finishing them on sub-interfaces with 
dot1q and then xconnecting the sob-interface to each l2tp tunnel to each 
respective branch. Is it correct or there is a better way?

Will this work?

Thanks in advance for your help
Ziv


************************************************************************************
This footnote confirms that this email message has been scanned by
PineApp Mail-SeCure for the presence of malicious code, vandals & computer 
viruses.
************************************************************************************

_______________________________________________
cisco-nsp mailing list  [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list  [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/

Reply via email to