Hi, I'm trying to make sure this following scenario can work. 3 remote sites, one is the HQ which has a switch that handles 2 vlans, let's say vlan 10 and vlan 20. The other two branches needs to be connected to the HQ and have a flat LAN between them and the HQ, but each branch to it's own vlan, branch 1 to vlan 10 and branch 2 to vlan 20. They must NOT see each other's traffic. Every site has a switch and a router (C2801 I think) Is it possible to do? If yes, then I was thinking about L2TPv3, but in this case I'd need to make two different xconnections between HQ-->Branch 1 and HQ-->Branch 2. How do I make this happen on the HQ router? I was thinking to bring the vlans via a trunk from the switch and then finishing them on sub-interfaces with dot1q and then xconnecting the sob-interface to each l2tp tunnel to each respective branch. Is it correct or there is a better way?
Will this work? Thanks in advance for your help Ziv ************************************************************************************ This footnote confirms that this email message has been scanned by PineApp Mail-SeCure for the presence of malicious code, vandals & computer viruses. ************************************************************************************ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
