Did you plug the programming plug into the radio, turn the volume all the way down and turn the radio on? Also, is the programming cable non- OEM?
On Sat, Dec 7, 2019, 4:49 PM Phil <[email protected]> wrote: > Thank you for reading this. > > I bought a Baofeng UV-82HP about four months ago and I cannot get Chirp > to read from the radio, or in fact to do anything with the radio. > > I'm running Chirp under Kubuntu and have tried every Chip daily version > over the past four months. This is the error message that I receive when > I attempt to read from the radio: > > "Radio did not respond" > > These are the entered parameters: > > /dev/ttyUSB0 > Baofeng > UV-82HP > > I have read and write access to the serial port which is the same port > that I use for several application including programming an Arduino > board. I have tried several different Baofeng models, just in case, with > the same result. > > I've trimmed the plastic from the plug so that it slips into the radio's > sockets more easily. I've attempted to read from the radio in both > channel and frequency modes. Finally, I've searched the Internet for > even the slightest clue but to no avail. > > I do not know anyone who owns a Baofeng radio or who uses Chirp. So this > mailing list is my last hope. > > Any clues at all will greatly appreciated. > > -- > Regards, > Phil > > _______________________________________________ > chirp_users mailing list > [email protected] > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to Dwayne Elliott at [email protected] > To unsubscribe, send an email to > [email protected] >
_______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
