Is the radio turned ON? Sometimes you have to not only turn them on but also crank the volume to max.
On Sat, Dec 7, 2019, 6:44 PM Tom Henderson <t...@henderson4.us> wrote: > Adding yourself to the "dialout" group should prevent you from having to > do this. > > Tom Henderson > > On 12/7/19 6:58 PM, Pat Anderson wrote: > > Oops, I should have said I am running Ubuntu Linux. Can't say anything if > you are running something other than Linux. > > > On Sat, Dec 7, 2019 at 5:56 PM Pat Anderson <anderson5...@gmail.com> > wrote: > >> Try this. Before you try to read from the radio, do "chmod 777 >> /dev/ttyUSB0". I have a Baofeng UV82HP and CHIRP reads and writes just >> fine once I have done this. >> >> Pat Anderson >> KD7OAC >> >> On Sat, Dec 7, 2019 at 5:48 PM Phil <phill...@gmail.com> wrote: >> >>> Thank you for reading this. >>> >>> I bought a Baofeng UV-82HP about four months ago and I cannot get Chirp >>> to read from the radio, or in fact to do anything with the radio. >>> >>> I'm running Chirp under Kubuntu and have tried every Chip daily version >>> over the past four months. This is the error message that I receive when >>> I attempt to read from the radio: >>> >>> "Radio did not respond" >>> >>> These are the entered parameters: >>> >>> /dev/ttyUSB0 >>> Baofeng >>> UV-82HP >>> >>> I have read and write access to the serial port which is the same port >>> that I use for several application including programming an Arduino >>> board. I have tried several different Baofeng models, just in case, with >>> the same result. >>> >>> I've trimmed the plastic from the plug so that it slips into the radio's >>> sockets more easily. I've attempted to read from the radio in both >>> channel and frequency modes. Finally, I've searched the Internet for >>> even the slightest clue but to no avail. >>> >>> I do not know anyone who owns a Baofeng radio or who uses Chirp. So this >>> mailing list is my last hope. >>> >>> Any clues at all will greatly appreciated. >>> >>> -- >>> Regards, >>> Phil >>> >>> _______________________________________________ >>> chirp_users mailing list >>> chirp_users@intrepid.danplanet.com >>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users >>> This message was sent to Pat Anderson at anderson5...@gmail.com >>> To unsubscribe, send an email to >>> chirp_users-unsubscr...@intrepid.danplanet.com >>> >> > _______________________________________________ > chirp_users mailing > listchirp_users@intrepid.danplanet.comhttp://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to Tom KM4UQB at t...@henderson4.us > To unsubscribe, send an email to > chirp_users-unsubscr...@intrepid.danplanet.com > > _______________________________________________ > chirp_users mailing list > chirp_users@intrepid.danplanet.com > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to Ryan McOmber at volksm...@gmail.com > To unsubscribe, send an email to > chirp_users-unsubscr...@intrepid.danplanet.com
_______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to arch...@mail-archive.com at arch...@mail-archive.com To unsubscribe, send an email to chirp_users-unsubscr...@intrepid.danplanet.com
