As far as I know, and please someone back me up on this. *VOLUME level on ANY radio does nothing during data transfers.* Dennis M. Wage (W9BOQ)
245 Corum Hill Road Castalian Springs, TN 37031 (615) 310-4242 Cell (615) 562-5128 Home http://hammondb3organ.net http://overdubs.net On Sun, Dec 8, 2019 at 1:58 AM Jardy via chirp_users < [email protected]> wrote: > All you have to do to get fake Prolific cables to work is to roll the > driver back to 3.2.0.0. Driver can be found at www.miklor.com. Real easy > to solve that ‘major’ problem. > > Jardy Dawson WA7JRD > > Message sent from some electronic device that only the Manufacturer of > said device really cares about. > > > On Dec 7, 2019, at 22:41, Jim Allyn <[email protected]> wrote: > > Cables using the Prolific chipset have always been a problem. I always > buy a cable with the FTDI chipset. I did recently program a radio with a > Prolific chipset cable, so maybe those drivers have been added to the > kernel now, too. There have been fake Prolific chipsets out in the wild > that are unreliable, so there's that problem, too. As far as I know FTDI > always works. > > > Thank you for reading this. > > I bought a Baofeng UV-82HP about four months ago and I cannot get Chirp > to read from the radio, or in fact to do anything with the radio. > > I'm running Chirp under Kubuntu and have tried every Chip daily version > over the past four months. This is the error message that I receive when > I attempt to read from the radio: > > "Radio did not respond" > > These are the entered parameters: > > /dev/ttyUSB0 > Baofeng > UV-82HP > > I have read and write access to the serial port which is the same port > that I use for several application including programming an Arduino > board. I have tried several different Baofeng models, just in case, with > the same result. > > I've trimmed the plastic from the plug so that it slips into the radio's > sockets more easily. I've attempted to read from the radio in both > channel and frequency modes. Finally, I've searched the Internet for > even the slightest clue but to no avail. > > I do not know anyone who owns a Baofeng radio or who uses Chirp. So this > mailing list is my last hope. > > Any clues at all will greatly appreciated. > > > > _______________________________________________ > chirp_users mailing list > [email protected] > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to Jardy at [email protected] > To unsubscribe, send an email to > [email protected] > > _______________________________________________ > chirp_users mailing list > [email protected] > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to Dennis Wage at [email protected] > To unsubscribe, send an email to > [email protected]
_______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
