Oops, I should have said I am running Ubuntu Linux. Can't say anything if you are running something other than Linux.
On Sat, Dec 7, 2019 at 5:56 PM Pat Anderson <[email protected]> wrote: > Try this. Before you try to read from the radio, do "chmod 777 > /dev/ttyUSB0". I have a Baofeng UV82HP and CHIRP reads and writes just > fine once I have done this. > > Pat Anderson > KD7OAC > > On Sat, Dec 7, 2019 at 5:48 PM Phil <[email protected]> wrote: > >> Thank you for reading this. >> >> I bought a Baofeng UV-82HP about four months ago and I cannot get Chirp >> to read from the radio, or in fact to do anything with the radio. >> >> I'm running Chirp under Kubuntu and have tried every Chip daily version >> over the past four months. This is the error message that I receive when >> I attempt to read from the radio: >> >> "Radio did not respond" >> >> These are the entered parameters: >> >> /dev/ttyUSB0 >> Baofeng >> UV-82HP >> >> I have read and write access to the serial port which is the same port >> that I use for several application including programming an Arduino >> board. I have tried several different Baofeng models, just in case, with >> the same result. >> >> I've trimmed the plastic from the plug so that it slips into the radio's >> sockets more easily. I've attempted to read from the radio in both >> channel and frequency modes. Finally, I've searched the Internet for >> even the slightest clue but to no avail. >> >> I do not know anyone who owns a Baofeng radio or who uses Chirp. So this >> mailing list is my last hope. >> >> Any clues at all will greatly appreciated. >> >> -- >> Regards, >> Phil >> >> _______________________________________________ >> chirp_users mailing list >> [email protected] >> http://intrepid.danplanet.com/mailman/listinfo/chirp_users >> This message was sent to Pat Anderson at [email protected] >> To unsubscribe, send an email to >> [email protected] >> >
_______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
