Van: Noel Chiappa via cctalk<mailto:cctalk@classiccmp.org> Verzonden: zaterdag 16 september 2017 15:52 Aan: cctalk@classiccmp.org<mailto:cctalk@classiccmp.org> CC: j...@mercury.lcs.mit.edu<mailto:j...@mercury.lcs.mit.edu> Onderwerp: Re: DEC H9xx rack parts needed
> does anyone have any spare "pivot bushings" for the DEC H9xx series > cabinets (H950, H960, etc)? (These are the short pieces with a conical > top which fit over the hinge pins, at the bottom.) > ... > I could also use some more of the pins (particularly the kind with the > hole drilled through them to take a roll pin) Someone asked for an image of these; here: http://ana-3.lcs.mit.edu/~jnc/tech/jpg/H9xxPinBushing.jpg is one. The pin in the picture is the kind without the hole at one end, but they are otherwise identical. (Ignore the retaining ring on the pin; those are easy to get, my local hardware store has them.) Noel Got the pivot bushing here in front of me, it’s yours. I am pretty sure I have one or two pins *with* a hole at one end, but I remember they are not perfectly straight. You will have to hammer them a bit to straighten them. I will check whether I can find those two pins, and send them to you in a “bubble envelop” marked as “old metal pivot parts”. Greetz, Henk