Van: Noel Chiappa via cctalk<mailto:cctalk@classiccmp.org> Verzonden: zaterdag 16 september 2017 01:04 Aan: cctalk@classiccmp.org<mailto:cctalk@classiccmp.org> CC: j...@mercury.lcs.mit.edu<mailto:j...@mercury.lcs.mit.edu> Onderwerp: DEC H9xx rack parts needed
Hi, does anyone have any spare "pivot bushings" for the DEC H9xx series cabinets (H950, H960, etc)? (These are the short pieces with a conical top which fit over the hinge pins, at the bottom.) I need at least one to hang a back door which I have. If nobody has any, they'd be easy to machine, so I might look into having a run made by some local machinists. (I do have a lathe, but have little lathe experience, so machining one of those myself is probably out of my range.) If it's someone with a CNC lathe/etc, I could probably get more made for little more than materials cost. If none turn up in response to this, I'll ask on the list about interest before I set off to find a machinist. I could also use some more of the pins (particularly the kind with the hole drilled through them to take a roll pin), if anyone has any of those spare. Thanks! Noel Hi Noel, I am going to my “museum” this afternoon, and will check. I am prety sure, I can help (and return a favor) 😊 Greetz, Henk