Ah nuts missed that one :) -- BR
Tony Sent from my iPad On 21 Apr 2013, at 18:14, Bob McCouch <[email protected]> wrote: > Look at all of the parameters that need to match for OSPF neighbors to > become adjacent and I think you'd find your answer. > > Typically you'd configure P2MP on all neighbors even of the FR was set > up as MP hub with P2P spokes. > > You can do what you were trying. You just need to see what didn't match. > > Bob > -- > Sent from my iPhone, please excuse any typos. > > On Apr 21, 2013, at 12:17 PM, Houssam Chahine <[email protected]> > wrote: > >> Good day, >> >> I configured ospf over the frame relay with Point to Multipoint on the Hub >> and point-to-point on the spokes. Somehow the neighbors didn't come up >> though i can ping the interfaces ip addresses. >> >> I tried to ping ospf multicast address with no replies. Once i configured >> ospf over the FR using broadcast all the neighbors come up. >> >> Is there anything i missed for the Point to multipoint? >> _______________________________________________ >> For more information regarding industry leading CCIE Lab training, please >> visit www.ipexpert.com >> >> Are you a CCNP or CCIE and looking for a job? Check out >> www.PlatinumPlacement.com >> >> http://onlinestudylist.com/mailman/listinfo/ccie_rs > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > http://onlinestudylist.com/mailman/listinfo/ccie_rs _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
