Hi, You could run a second ospf process on your router with the tunnel interface and redistribute between the processes. That would make all routes from the tunnel appear as E1/2. Effectively, this would split your area in two so consider the number of distribution points into the area and whether you will introduce loops.
Hope that helps, Andres Villalva On 07/03/2012 4:27 AM, "Jawed Lashari" <[email protected]> wrote: Hey Guys, I am long time follower of this group and need little help this time. When redistributed in to OSPF, route appears in my routing table as either E1 or E2, depend how you redistribute. I want to appear route as O ( Intra area ) when I redistribute to OSPF. Is that possible? I have done research but have not find anything. Example: I am learning network ( 192.168.1.x) from MPLS cloud and GRE over Internet but it is getting preferred through GRE as it appears as O ( Intra area ) route and I want to prefer MPLS route which is appearing as E2 route because I am redistributing from BGP ( Cloud ) to OSPF. I would appreciate if anyone has solution to this problem. /Thanks _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
