Perfectvisuon does On Fri, Jul 16, 2021, 12:32 PM Chuck McCown via AF <af@af.afmug.com> wrote:
> I understand and wish that enclosure existed but the company that makes > that particular enclosure will not do a version like you ask. I would love > it if there were 2 or 3 entrances in that enclosure. They make larger ones > but that is a problem too, they are larger. Look at our multiple line > surge products. We put up to 8 surge protectors in the same box. That is > a good box with a good seal. > > There is an intermediate size but I don’t think it seals very well. And > of course any larger box costs more. Furthermore they now require minimum > purchase quantities of 1000 pcs. That is a gamble in and of itself. > Will customers pay say $5 more to have three entrances. Cost me probably > $15K just to find out. > > *From:* Carl Peterson > *Sent:* Friday, July 16, 2021 10:49 AM > *To:* AnimalFarm Microwave Users Group > *Subject:* Re: [AFMUG] Cambium Force 300 Ethernet question > > We have recently seen similar issues when using Chuck's surge > suppressors. Not sure what changed, the RJ 45s, The jack Chuck uses, or my > techs but we figured out that it was caused by the cable getting pulled > sideways in the surge enclosure and the tolerance stack on the RJ/RJ jack > just not working in our favor. Now we add a zip tie in the little > enclosure to force a bend/cross in the in/out cable. > > P.S. If you are reading this Chuck we would really really like an > enclosure with a separate in/out feed similar to the 600SS or something > like that so the cable can go straight up into the jack and not get pulled > sideways. > > On Thu, Jul 15, 2021 at 10:44 PM Nate Burke <n...@blastcomm.com> wrote: > >> I've put up alot of the F300, haven't seen any problems. Bad cable or >> Radio? Did you try a different POE? 9/10 times Ethernet seems to be a >> problem with the termination and/or cable. I've done 1000's of ends, but >> just the other day I did one with one blue and green wire switched, I think >> that caused weird Ethernet problems. Of course it was the end at the radio >> and not the easy-to-get-to inside connection. >> >> On 7/15/2021 9:32 PM, Jaime Solorza wrote: >> >> Installed a PTP link with great signal but Ethernet port will not lock >> at 1000FDX...only 100FDx...if i force it it loses connection or 10mbps >> hex... >> Latest firmware... >> Any ideas? >> I even put a Trendnet Ethernet switch between Poe and Edgeswitch... >> Thanks >> >> >> >> -- >> AF mailing list >> AF@af.afmug.com >> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >> > > > -- > > Carl Peterson > > *PORT NETWORKS* > > 401 E Pratt St, Ste 2553 > > Baltimore, MD 21202 > > (410) 637-3707 > > ------------------------------ > -- > AF mailing list > AF@af.afmug.com > http://af.afmug.com/mailman/listinfo/af_af.afmug.com > -- > AF mailing list > AF@af.afmug.com > http://af.afmug.com/mailman/listinfo/af_af.afmug.com >
-- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com
