There is not enough room to make a hole large enough for a grommet that will
allow a cat5 plug to pass. We have about .735” to work with. You need a
minimum of .750 hole and the grommet itself is 1” dia.
I could do a split grommet that would just fit the CAT5 but then you will have
to install the grommet with cable filling it and that will be a big pain
forcing it in. The other seal that is already there slides out so you are not
having to force a round grommet into the hole.
It is easy if the grommet doesn’t have anything going through the center when
you install it.
I doubt no one wants to feed the wire through then install the plug.
From: Jason McKemie
Sent: Friday, July 16, 2021 11:56 AM
To: AnimalFarm Microwave Users Group
Subject: Re: [AFMUG] Cambium Force 300 Ethernet question
I've drilled holes in the bottom of the DC SS enclosures, directly below the
connectors. Works well enough for those, it would be a bit more of a pain with
the RJ45 connector though since you'd have to install the end afterwards.
On Fri, Jul 16, 2021 at 11:51 AM Carl Peterson <cpeter...@portnetworks.com>
wrote:
We have recently seen similar issues when using Chuck's surge suppressors.
Not sure what changed, the RJ 45s, The jack Chuck uses, or my techs but we
figured out that it was caused by the cable getting pulled sideways in the
surge enclosure and the tolerance stack on the RJ/RJ jack just not working in
our favor. Now we add a zip tie in the little enclosure to force a bend/cross
in the in/out cable.
P.S. If you are reading this Chuck we would really really like an enclosure
with a separate in/out feed similar to the 600SS or something like that so the
cable can go straight up into the jack and not get pulled sideways.
On Thu, Jul 15, 2021 at 10:44 PM Nate Burke <n...@blastcomm.com> wrote:
I've put up alot of the F300, haven't seen any problems. Bad cable or
Radio? Did you try a different POE? 9/10 times Ethernet seems to be a problem
with the termination and/or cable. I've done 1000's of ends, but just the
other day I did one with one blue and green wire switched, I think that caused
weird Ethernet problems. Of course it was the end at the radio and not the
easy-to-get-to inside connection.
On 7/15/2021 9:32 PM, Jaime Solorza wrote:
Installed a PTP link with great signal but Ethernet port will not lock
at 1000FDX...only 100FDx...if i force it it loses connection or 10mbps hex...
Latest firmware...
Any ideas?
I even put a Trendnet Ethernet switch between Poe and Edgeswitch...
Thanks
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
Carl Peterson
PORT NETWORKS
401 E Pratt St, Ste 2553
Baltimore, MD 21202
(410) 637-3707
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--------------------------------------------------------------------------------
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
