Thanks! I'm upgrading the firmware now, the radio was on 3.5.1
Ok, ready to pull my hair out now.
Radios were on 3.5.1, just upgraded to 3.5.6. The 2.4 SM (nonGPS), has
the option to disable the Ethernet port, but the 2.4ap (nonGPS) does not
have that option.
If the Radio is set as an AP, does that option go away?
AP Radio (EPMP1000 NonGPS)
SM Radio (EPMP1000 NonGPS)
It's an interesting setup, CustomerA provides POE and is connected via
Ethernet to the 2.4 radio. The Aux Port of the 2.4 radio powers a 5ghz
Feed radio. Customer B connects via RF to the 2.4 radio. CustomerA
isn't paying their bill, so I need to turn them off.
CustomerB owns the house of CustomerA, so I'm not worried about them
getting pissed off and unplugging it, as CustomerB can just go plug it
in again.
On 12/4/2019 8:28 AM, Adam Moffett wrote:
This is a 2.4 unit on 3.5.6.....but it looks like you can turn off the
primary port.
If that option isn't there on yours, what about disabling the switch
port at the bottom or just unplugging it at the bottom?
On 12/4/2019 9:19 AM, Nate Burke wrote:
Is there a way to disable the Ethernet on the primary port but leave
the aux port active? You can Disable the Aux port, but there isn't a
setting to disable the Primary port. I need to kill the traffic on
the port that is providing the POE, but leave the aux port active.
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
