On Wed, Sep 13, 2017 at 12:27 AM, Ayoub Zaki <ayoub.z...@embexus.com> wrote:
> I ran into the same problem: > > ENABLE_UART = "1" is not enough you should also add INSTALL_append= " > rpi-config" to your local.conf and Serial port will be enabled. > this should be automatically pulled in if you built a sdcard image. > > On 12.09.2017 14:09, yahia farghaly wrote: > > I have bitbaked rpi-hwup-image for raspberry pi 3 on sd card and connected > the serial ports to *usb to ttl device* . i have set the minicom to > port: /dev/ttyUSB0 > baud rate: 115200 > the image is booting fine and i can see the prompt on the screen but > cannot see in my serial console using minicom. > *is serial enabled by default for this image ? * > i also tried ENABLE_UART = "1" in local.conf but doesn't help. > > how to enable it ? and what the serial device name with respect to > raspberry pi > > thanks, > > -- > Yahia Farghaly > Graduated from Faculty of Engineering - Electronics and Communications > Department at Cairo University. > Linkedin <https://linkedin.com/in/yahiafarghaly> - GitHub > <https://github.com/yahiafarghaly> > > > > > > > > -- > > Ayoub Zaki > Embedded Systems Consultant > > Vaihinger Str. 2/1 > 71634 Ludwigsburg > > e-mail: ayoub.z...@embexus.com > Tel: +49176-62901545 <+49%20176%2062901545>https://embexus.com > > > -- > _______________________________________________ > yocto mailing list > yocto@yoctoproject.org > https://lists.yoctoproject.org/listinfo/yocto > >
-- _______________________________________________ yocto mailing list yocto@yoctoproject.org https://lists.yoctoproject.org/listinfo/yocto
