robert, what is your network hardware? dumb switches isolate traffic, so one physical port cannot listen to traffic on a different physical port. hubs (remember those?), on the other hand, let every port see traffic on every other port. if you have a managed switch, then you can probably use the switch's management interface to mirror ports, letting one physical port see the traffic happening on a different physical port.
m > On Nov 20, 2024, at 19:05, Robert Turner <rturner2...@gmail.com> wrote: > > I have weewx installed and the interceptor driver setup. I have a wifi > station that has built in wunderground updating. On my pi the station is > connected to the wlan0 which is setup as an accesspoint with routing setup to > eth0 which has internet access. > > The station is connecting and sending data to wunderground. I can see it > constantly updating on the site. With the interceptor driver in sniff it is > not getting the data. > > I ran the driver directly > > sudo PYTHONPATH=/usr/share/weewx python3 interceptor.py --device=wu-client > --mode=sniff --iface=wlan0 --filter="src 192.168.5.131 and dst port 80" > > The ip address is correct for the station. I let it run for a period of time > and don't see any output. > > Thanks -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to weewx-user+unsubscr...@googlegroups.com. To view this discussion visit https://groups.google.com/d/msgid/weewx-user/D738FB98-4075-46BD-B2DA-06B0288E2E10%40gmail.com.
