On 22/03/2023 18:06, jmalo...@umass.edu wrote:
When the frequency is called back, it gives back that it is set to 100
Khz. The lowest it goes is 5 hz.
_______________________________________________
USRP-users mailing list --usrp-users@lists.ettus.com
To unsubscribe send an email tousrp-users-le...@lists.ettus.com
Your command-line is here:
|./rx_samples_to_file --nsamps 3000000 --channel 0 --ant "RX2" --subdev
"A:0" --gain 50 --rate 3e6 --freq 100000
Which means you're asking the hardware to tune to a center frequency of
100kHz. That isn't possible with this hardware.
I refer you to the datasheet here:
https://www.ettus.com/wp-content/uploads/2019/04/USRP-N320-Datasheet-2.pdf
|
_______________________________________________
USRP-users mailing list -- usrp-users@lists.ettus.com
To unsubscribe send an email to usrp-users-le...@lists.ettus.com
