Thanks Rob, I was actually wondering that! <end transmission>
> On Jan 14, 2022, at 09:26, Rob Kossler <rkoss...@nd.edu> wrote: > > > Forgot to mention, there are some nice LEDs on the LO Tx Outputs that will > tell you if you have a given port enabled. > >> On Fri, Jan 14, 2022 at 9:25 AM Rob Kossler <rkoss...@nd.edu> wrote: >> Hi Paul, >> Based on the block diagram, I think I would set both LOs to use an external >> source. I would set the Tx0 export the LO on Tx Output 0 and then route it >> directly back into Tx Input 1 which then goes to a 1:2 splitter to feed both >> inputs. In addition to exporting the LO and setting the LO source to >> external for both ports, you also need to enable the Tx Output 0 (disabled >> by default). I've forgotten the command to do so. >> Rob >> >> >> >>> On Fri, Jan 14, 2022 at 1:11 AM Paul Atreides <maud.dib1...@gmail.com> >>> wrote: >>> I am trying to configure the N321 to take some TX phase measurements >>> between RF0 and RF1 >>> I have updated the file system to the latest release using the KB guidance. >>> >>> My host/software side is: >>> GNURadio 3.9.5 >>> UHD 4.1.0.5 >>> Ubuntu 20.04 >>> >>> My gr-uhd block has the LO settings: >>> Channel 0 export = true >>> Channel 0 LO = internal >>> >>> Channel 1 export = false >>> Channel 1 LO = external >>> >>> On the hardware side am I understanding the LO diagram correctly that in >>> order to achieve the highest phase accuracy between channels i need to >>> share the LO between the transmit ports of RF0 and RF1? >>> If so, would I do that by physically connecting the TX LO OUT0 (really 0-3) >>> to TX LO IN1? >>> >>> Am I missing anything obvious for the settings and/or is there a more >>> desirable way to do this? >>> >>> Thanks >>> >>> <end transmission> >>> _______________________________________________ >>> USRP-users mailing list -- usrp-users@lists.ettus.com >>> To unsubscribe send an email to usrp-users-le...@lists.ettus.com
_______________________________________________ USRP-users mailing list -- usrp-users@lists.ettus.com To unsubscribe send an email to usrp-users-le...@lists.ettus.com
