Hello all, I am using UHD 4.0 and when I look at the FPGA using Vivado over JTAG, I see that the FPGA is not programmed. So I send HG bitstream which is downloaded with "uhd_images_downloader" via JTAG to X310 (USRP-2945R). I am able to successfully ping the X310 and observe daughterboards and other information with "uhd_usrp_probe". With "uhd_fft" I can properly look at the spectrum of the signal.
However, when I want to flash the UHD 4.0 X310 HG image with "uhd_image_loader", I keep getting "Error: RuntimeError: Device reported an error during initialization.". When I read the contents of the EEPROM with “usrp_burn_mb_eeprom“, X310 appears to be in revision 7. I tried to write to the flash after updating to the revision 8, but I was unsuccessful again. I can't use X310 without JTAG because of this interesting issue. If you can point me towards solution, I would be grateful. Thank you so much.
_______________________________________________ USRP-users mailing list -- usrp-users@lists.ettus.com To unsubscribe send an email to usrp-users-le...@lists.ettus.com
