Hello!
> I want to know if I can use N200 with UBX160
Sadly, no. The N200 needs an anti-alias filter of at most 50 MHz bandwidth (one-sided) for
effectively alias-free operation, and a UBX160 has 80 MHz.
> My goal is to run the N200 at 100Msps to receive 100MHz bandwidth of signal.
That is impossible. The N200 has a master clock rate of 100 MHz, that is true, but it's
impossible to get that amount of data out of the N200 (the Ethernet is much too slow for
it, and there's no significant memory on the N200 to store it).
> Which means that UBX40 is not the right choice.
More importantly, the N200 is not the right choice!
> I don't see the UBX160 on the recommended compatible products of N series
devices
Correct!
> But I've found out the datasheet of UBX160 specified that UBX160 is compatible with
both X and N series.
Oh, that is indeed an error in the datasheet! Thank you for pointing this out
to us!
> So, will this combination work?
No; if you want 100 MHz bandwidth, you will need a X300/X310 with a UBX160, or a USRP
N300/N310/N320/N321 or X400 alone. I'd personally go for X300+UBX160, which is probably
the most cost-effective solution.
Best regards,
Marcus Müller
DISCLAIMER: Any attached Code is provided As Is. It has not been tested or
validated as a product, for use in a deployed application or system, or for use
in hazardous environments. You assume all risks for use of the Code. Use of the
Code is subject to terms of the licenses to the UHD or RFNoC code with which
the Code is used. Standard licenses to UHD and RFNoC can be found at
https://www.ettus.com/sdr-software/licenses/.
NI will only perform services based on its understanding and condition that the
goods or services (i) are not for the use in the production or development of
any item produced, purchased, or ordered by any entity with a footnote 1
designation in the license requirement column of Supplement No. 4 to Part 744,
U.S. Export Administration Regulations and (ii) such a company is not a party
to the transaction. If our understanding is incorrect, please notify us
immediately because a specific authorization may be required from the U.S.
Commerce Department before the transaction may proceed further.
On 03.12.21 08:34, 翁偉吾 wrote:
Hi, I want to know if I can use N200 with UBX160. My goal is to run the N200 at 100Msps
to receive 100MHz bandwidth of signal. Which means that UBX40 is not the right choice.
I don't see the UBX160 on the recommended compatible products of N series devices. But
I've found out the datasheet of UBX160 specified that UBX160 is compatible with both X
and N series. So, will this combination work? Is there going to be some aliasing issue?
_______________________________________________
USRP-users mailing list -- usrp-users@lists.ettus.com
To unsubscribe send an email to usrp-users-le...@lists.ettus.com
_______________________________________________
USRP-users mailing list -- usrp-users@lists.ettus.com
To unsubscribe send an email to usrp-users-le...@lists.ettus.com
