I have an RFNOC block that, based on a control register can either decimate the signal it's working on or leave the output rate the same as the input rate. If I set the control register to an initial value (either decimate, or not decimate) and let the system run, it works fine in either mode. If I try to change the decimation mode while the block is running, I start getting timeout errors. I currently use the axi_rate_change block to help handle the rate change, and have tried to synchronize changing the block's mode (decimate or not) with the axi_rate_change's clear_user flag. Any thoughts?
Thanks, Andrew -- Information contained, linked, or attached to this email and all verbal communications from WhiteFox Defense to your entity in the prior 30 days constitute proprietary and confidential information unless otherwise indicated and is therefore subject to obligations in any executed confidentiality agreements. Further, this email is intended solely for the use of the individual or entity to whom they are addressed. If you are not the intended recipient and this message has been addressed to you in error, please promptly notify i...@whitefoxdefense.com <mailto:i...@whitefoxdefense.com> and destroy all copies of the message and any attachments. This email and attachments may contain technical data as defined in the International Traffic In Arms Regulations (ITAR) 22 CFR 120.10 or the Export Administration Regulations (EAR) 15 CFR Parts 730 – 780. Export of this material may be controlled by these regulations and may not be exported or transferred to non-U.S. persons without prior written approval from the U.S. government.
_______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
