Hello, Thanks for your quick response!
so, with B200 mini, it is not possible to use GNU radio to work on board itself, Can you please suggest me the software such as labview can be used on it(USRP-B200 mini) without the host computer or only VHDL-verilog is supported on this particular SDR. Thanks for your support in advance! With Best Regards, Maitry Raval, ----- Original Message ----- From: "usrp-users" <usrp-users@lists.ettus.com> To: "usrp-users" <usrp-users@lists.ettus.com> Sent: Thursday, January 10, 2019 11:40:59 AM Subject: Re: [USRP-users] regrading GPIO header connector in USRP-B200 mini On 01/10/2019 01:03 AM, Maitry Raval via USRP-users wrote: > Hello, > > Ok, but if B200 mini cannot run GNUradio application by itself, then Is there > any other procedure by which one can dump the GNU radio flow graph generated > code(python or C++) in USRPb200 mini? > > It would be grateful, if you could provide some guidance. > > With Best Regards, > Maitry Raval, > > The B200mini IS NOT, per se, a general-purpose computer. So, to directly answer your question, no, that is not possible. The B200mini does have an FPGA, and some amount of "spare" room in that FPGA. But you'd have to completely-reimagine your algorithms in FPGA code. There's no "dump my Gnu Radio flow-graph into the FPGA". _______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com _______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
