On 06/18/2018 09:46 PM, Ayaz Mahmud wrote:
Hi,
Thanks for suggestion.
I have taken the rx_ofdm.grc (as the receiver) & tx_ofdm.grc as
transmitter in the /OFDM/example/.
In this case, if I choose number of channel = 2 at RX USRP, then a new
output port is turned on, which must be connected to the next block
(snap attached for better understanding). But the next block is
already connected to the Ch0 of USRP, so an error is shown.
What will be the workaround in this situation?
Thanks you,
Ayaz
*From: *Marcus D. Leech via USRP-users <mailto:usrp-users@lists.ettus.com>
*Sent: *Monday, June 18, 2018 6:00 PM
*To: *usrp-users@lists.ettus.com <mailto:usrp-users@lists.ettus.com>
*Subject: *Re: [USRP-users] Configuration for 2nd RX2 antenna failed
in B210
On 06/18/2018 07:13 PM, Ayaz Mahmud via USRP-users wrote:
Hi,
My platform is B210. I am trying to setup 1 x TX (1^st USRP) and 2
x RX (2^nd USRP).
I am able to transfer a file using OFDM from one USRP to other
with single TX-RX antenna (2.421 GHz). But I am unable to
configure the 2 x RX antenna.
*_Configured at Receiver USRP (Source):_*
Mb0: Subdev spec àA:A A:B
Ch0 antenna àRX2
With this setup I cannot see any LED on the 2^nd RX2 port. Can you
point out any mistake or suggestion for troubleshoot?
Thanks,
Ayaz
Yes, specify RX2 for the 2nd channel in your setup.
Ok, well, now I don't know what it is you're trying to do. You want to
receive on two antennae, but you don't want two channels--does that sum it
up? In which case, the answer is you can't do that.
_______________________________________________
USRP-users mailing list
USRP-users@lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
